Automatic sensor faucets are convenient to use but some may think it’s difficult to maintain the faucets OR they have no idea how to do trouble shooting, after all the electronic faucets are connected power such batteries or main power. Actually, it’s quite easy to make it if read below and you will find you can handle everything by yourself easily.

Following are the key points for maintaining the touchless faucets in daily life. Firstly, you should always keep faucet surface clean and dry. DO NOT immerse faucet in water for sure. At the same time, use damp towel or cotton cloth to wipe gently if necessary. Secondly, you should avoid any rocking or violent motion after faucets installed onto the basin. At last but not the least, Remember that DO NOT use any acid or alkaline detergents for cleaning. Follow these three suggestions, the automatic faucets will be well protected and maintained for daily use.

How to do trouble shooting if you start using the sensor faucets? Do not worry. We have a list here to teach you how to make it.

Dirt on sensor caseClean the sensor case

Problem Possible Reason Suggested Solution
No water flow Batteries run out Replace batteries
Main water supply is shut off Turn main water supply on
Dirt on water filter net Clean the water filter net
Water pressure is not applicable Make sure water pressure is between 0.05-0.7MPA
Have a continuous water flow problem Batteries run out Replace batteries
Low water pressure Make sure water pressure is between 0.05-0.7MPA
Having leakage after turning off faucet Low water pressure Make sure water pressure is between 0.05-0.7MPA
Dirt on water filter net Clean the water filter net
Low water flow Low water pressure Make sure water pressure is between 0.05-0.7MPA
Dirt on water filter net Clean the water filter net
Short battery life span Bad/old batteries Replace batteries
Undetected Batteries run out Replace batteries